You invite a friend to a party, and the invite fails. You join a match, and the voice chat goes silent. Then you open the network settings and see the word that explains it: Strict. The good news is that the xbox nat type strict fix is usually a router setting, not a broken console.
This guide walks through the xbox nat type strict fix in the order you should try it, from the quickest change to the more involved ones.
Short version: turn on UPnP in your router and restart the router and the console. The full xbox nat type strict fix below explains each step.

Table of Contents
- What Does NAT Type Mean on Xbox?
- How to Check Your NAT Type on Xbox
- Fix 1: Turn On UPnP on Your Router
- Fix 2: Forward the Xbox Ports Manually
- Fix 3: Remove Double NAT
- Fix 4: Check for CGNAT and Talk to Your ISP
- Other Fixes Worth Trying
- Frequently Asked Questions
What Does NAT Type Mean on Xbox?
SUMMARY: NAT decides which players can connect to your console, and the xbox nat type strict fix starts with the three results: Open, Moderate and Strict.
NAT stands for Network Address Translation. NAT is the set of rules the router uses to decide which incoming connections are allowed through.
Xbox reports one of three results, and the xbox nat type strict fix matters most when yours says Strict. Open is best: play with anyone and host matches. Moderate is the middle result: you can play with Open and Moderate players, but not always with Strict players. Strict is the most restrictive: you can usually only connect to players who have Open NAT, and hosting is unreliable.
| NAT Type | Xbox Label | Who You Can Play With | What You Notice |
|---|---|---|---|
| Open | Open | Open, Moderate and Strict players | Everything works |
| Moderate | Moderate | Open and Moderate players | Mostly fine |
| Strict | Strict | Open players only | Party chat and hosting fail |
The usual signs that the xbox nat type strict fix applies to you are party chat that cuts out, invites that fail, and matchmaking that takes far longer than it should.
How to Check Your NAT Type on Xbox
SUMMARY: Check the result on the console first, because the xbox nat type strict fix depends on what the Xbox reports.
Press the Xbox button, then go to Profile and system, then Settings. Select General, then Network settings. Your NAT type appears under Current network status, shown as Open, Moderate or Strict. Select Test NAT type to refresh the result.
Look for warning messages next to the NAT type. “Double NAT detected” means two devices in your home are both doing NAT, covered in Fix 3 below. “UPnP not successful” means the router did not create the automatic port mapping the console asked for, which points to Fix 1. The xbox nat type strict fix follows Microsoft’s order: check the result, read the warnings, then change router settings. Microsoft’s own NAT error troubleshooting page covers these warnings.
Fix 1: Turn On UPnP on Your Router
SUMMARY: UPnP is the easiest part of the xbox nat type strict fix, letting the Xbox open the ports it needs automatically.
UPnP stands for Universal Plug and Play. When it is on, your Xbox can ask the router to open the exact ports it needs, and the router closes them again afterwards. The xbox nat type strict fix very often ends here, with a single toggle and a restart.
Open a browser on your home network and type your router’s admin address, usually 192.168.1.1 or 192.168.0.1. Look for the UPnP setting, normally under Advanced, WAN or NAT settings. Switch UPnP on, save, then restart the router and the Xbox. Then go back to Network settings and select Test NAT type again.
If UPnP was already on and the result is still Strict, switch it off, save, restart the router and console, then switch it back on and restart both again. If the result changes to Open or Moderate, the xbox nat type strict fix has worked. If it is still Strict, move on to the next fix.
Fix 2: Forward the Xbox Ports Manually
SUMMARY: If UPnP does not work, the xbox nat type strict fix continues with manual port forwarding to a fixed IP address.
Port forwarding is a manual version of what UPnP does automatically: rules on the router send traffic on specific ports straight to your Xbox. Before you create any rule, give the Xbox a fixed address, because a rule points to one IP address. The reliable way is a DHCP reservation: find the Xbox in the router’s connected devices list and reserve its current address.
Microsoft lists the ports Xbox Live needs in its network ports support page, and the table below matches that list exactly. Forward each port to the reserved IP address of your Xbox, choosing TCP, UDP or both as the table says.
| Port | Protocol | What It Is Used For |
|---|---|---|
| 88 | UDP | Xbox Live authentication |
| 3074 | UDP and TCP | Multiplayer and party chat |
| 53 | UDP and TCP | DNS |
| 80 | TCP | Web traffic |
| 500 | UDP | IPsec security |
| 3544 | UDP | Teredo tunnelling |
| 4500 | UDP | IPsec NAT traversal |
Port 3074 matters most, but forward the full set to be safe. After saving the rules, restart the router and the console, then run Test NAT type again. If the result is now Open or Moderate, the xbox nat type strict fix has worked. If “Teredo is unable to qualify” appears, that usually points to UDP port 3544 or to UPnP being blocked.
If two Xbox consoles share one network, only one can use port 3074 at a time through manual forwarding. Go to Network settings, then Advanced settings, then Alternate port selection, and choose Automatic, which lets the console pick a different port when 3074 is in use. This is a common finishing step in the xbox nat type strict fix for homes with two consoles.

Fix 3: Remove Double NAT
SUMMARY: Double NAT is the most common reason the xbox nat type strict fix stalls after UPnP.
Double NAT happens when two devices do NAT one after the other, usually a provider gateway with your own router behind it. The Xbox sits behind the second NAT layer, and UPnP on your own router cannot open anything on the provider’s gateway. The xbox nat type strict fix cannot finish until one of those two NAT layers is removed.
The clean fix is to put the provider’s gateway into bridge mode, sometimes called modem mode, so it only passes the connection through and your own router manages the network. Do that in the gateway’s admin page, or ask your provider to enable it. Once bridge mode is on, the xbox nat type strict fix can move forward with UPnP or port forwarding on your own router alone. Restart the modem, router and console in that order, then run Test NAT type again. If your provider will not allow bridge mode, put your own router’s IP address in the DMZ of the provider’s gateway instead.
Fix 4: Check for CGNAT and Talk to Your ISP
SUMMARY: If the xbox nat type strict fix still fails, the block may sit at your internet provider as carrier-grade NAT.
CGNAT stands for carrier-grade NAT: your internet provider shares one public IPv4 address between many customers, instead of giving your home its own. Your router then sits behind a second layer of NAT run by the provider, and no setting on your router can open ports through it. CGNAT is common on 5G home internet and satellite services such as Starlink. If you are behind CGNAT, the xbox nat type strict fix has to involve the provider.
Check for CGNAT: compare your router’s WAN address with a “what is my IP” website. If they do not match, or if the router’s WAN address starts with 100.64 through 100.127, you are behind CGNAT, because that 100.64.0.0 to 100.127.255.255 range is reserved for carrier-grade NAT. The xbox nat type strict fix only moves to the provider once this check confirms CGNAT.
Ask your provider for a public IPv4 address, sometimes sold as a static IP. That is the proper fix: once your router has its own public address, UPnP and port forwarding start working again. Turning on IPv6 on the router can also help in some setups.
Other Fixes Worth Trying
SUMMARY: A few smaller steps round out the xbox nat type strict fix: a restart, a wired connection, and the DMZ.
Start with the simplest step: restart everything. Turn the Xbox, router and modem off, wait about a minute, and switch them back on in order, modem first, then router, then console. The xbox nat type strict fix is worth retrying from the top after a restart, because a stale UPnP mapping can look like a settings problem.
Next, try a wired connection if you normally play on Wi-Fi: an Ethernet cable is more stable, though it does not change the NAT type by itself. NAT problems affect multiplayer across platforms, so if you also play with friends on PlayStation, see our guide to the best PS5 multiplayer games.
The DMZ is the last resort, for a game console only, never a PC. It places one device outside the router’s firewall so all ports are open to it, which almost always produces an Open NAT but removes the firewall protection. The DMZ is the final step in the xbox nat type strict fix, not a shortcut: enter the reserved IP address of your Xbox in the DMZ setting, save, restart the router and console, and test again. If even the DMZ leaves the NAT type Strict, the cause is almost certainly CGNAT, so go back to Fix 4.
Frequently Asked Questions
SUMMARY: The questions players ask most often about the xbox nat type strict fix.
Can I still play online with a Strict NAT type?
Yes, but only with players who have Open NAT. Party chat, invites and hosting suffer most. The xbox nat type strict fix is worth doing if you play with the same group regularly.
Does a Strict NAT type make my internet slower?
No. NAT type has nothing to do with download speed, upload speed or ping. Speed depends on your plan, Wi-Fi signal and servers, while NAT type depends only on how your router handles incoming connections. That is why the xbox nat type strict fix is about router settings, not a faster plan.
How long does the xbox nat type strict fix take?
Most people finish in ten to twenty minutes. Double NAT and CGNAT take longer. Test after each step.
Is it safe to use the DMZ for my Xbox?
It is safer than for a PC, but it still removes the firewall for that device, so it should only be a last resort. A console is a closed system, which is why the DMZ is treated as acceptable for a console and not for a computer. Only put the Xbox itself in the DMZ.
Why is my NAT type Strict on 5G home internet or Starlink?
Those connections very often use CGNAT, so no router setting can open the ports. The xbox nat type strict fix there is to ask the provider for a public IPv4 address.
Do I need Open NAT, or is Moderate good enough?
Moderate is good enough for most players: you can play with Open and Moderate players, join parties, and enjoy normal matchmaking. Open is better if you host games often or run a second console. The xbox nat type strict fix aims for Open, but if you land on Moderate and everything works, stop there.
Once your NAT type shows Open after the xbox nat type strict fix, invites go through, party chat stays connected, and you can host for your friends. If you are looking for something to play, our list of the best video games in 2026 is a good place to start, and if you play on Game Pass, check which Xbox Game Pass games are leaving in November 2026 before they go. Find more guides on the GameCresta homepage.
For More Updates Visits: GAME CRESTA






2 Responses